EN 14647:2005 – Calcium aluminate cement – Composition, specifications and conformity criteria

EN 14647:2005 - Calcium aluminate cement - Composition, specifications and conformity criteria

1 Scope
This European Standard gives a general definition of calcium aluminate cement and its composition. It includes requirements for the mechanical, physical and chemical properties and also states the conformity criteria and the related rules.
Calcium aluminate cement used as a constituent material of formulated mixes for specific applications (e.g. dry mixes) is outside the scope of this European Standard.
NOTE Guidance for the correct use of calcium aluminate cement in concrete and mortars is given in Annex A.
2 Normative references
The following referenced documents are indispensable for the application of this European Standard.
For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 197-2:2000, Cement — Part 2: Conformity evaluation
EN 196-1, Methods of testing cement — Part 1: Determination of strength
EN 196-2, Methods of testing cement — Part 2: Chemical analysis of cement
EN 196-3, Methods of testing cement — Part 3: Determination of setting time and soundness
EN 196-7, Methods of testing cement — Part 7: Methods of taking and preparing samples of cement
3 Terms and definitions
For the purposes of this European Standard, the following terms and definitions apply.
3.1
autocontrol testing
continual testing by the manufacturer of cement spot samples taken at the point(s) of release from the factory/depot
3.2
control period
period of production and dispatch identified for the evaluation of the autocontrol test results
3.3
characteristic value
value of a required property outside of which lies a specified percentage, the percentile P k of all the values of the population
3.4
specified characteristic value
characteristic value of a mechanical, physical or chemical property which in the case of an upper limit is not to be exceeded or in the case of a lower limit is, as a minimum, to be reached
3.5
single result limit values
value of a mechanical, physical or chemical property which – for any single test result – in the case of an upper limit is not to be exceeded or in the case of a lower limit is, as a minimum, to be reached
EN 14647:2005 – Calcium aluminate cement – Composition, specifications and conformity criteria

Leave a Reply

Your email address will not be published. Required fields are marked *